Dynamic Thermal Modelling (DTM)
Whilst Part L1 Volume 2 and SBEM sets the building regulation compliance ‘back stops’ for minimum construction standards, plant efficiencies and glazing areas, it is not a design tool and gives no indication of how an occupied building will perform.
The SBEM does not size plant, estimate heat gains or losses or take into account any internal heat gains from occupants, office equipment or plant; consequently SBEM will not demonstrate that an internal environment is overheating.
In fact in ADL1 Volume 2 paragraph 2.52 Note states:
‘therefore the developer should work with the design team to specify what constitutes an acceptable indoor environment in the particular case, and carry out the necessary design assessments to develop solutions that meet the agreed brief. Some ways of assessing overheating risk are given in CIBSE TM37 Design for improved solar shading control and, for education buildings, in BB101 Ventilation in school buildings’.
HIBEC can assist in the design team using Dynamic Thermal
Modelling (DTM) of the building.
In essence, the next stage after the SBEM has been used to set the minimum standards is for the design team to select the plant which will prevent a poor internal environmental air quality, in other words, stop the buildings becoming hot and stuffy.
We use IES/TAS dynamic simulation software using CIBSE hourly weather data to 3D model buildings enabling us to provide:
- Thermal comfort calculations i.e. temperature out of range
- Indoor Air Quality & Ventilation calculations i.e. CO2 ppm levels
- Overheat Risk Assessments
- Heat gain and heat loss, air flow and plant sizing calculations
- Daylighting calculations
- Concept Energy Models and Developed Energy Models
- BREEAM Hea 4 reports
- Bespoke analysis of clients specifications
- Operational Energy Performance (TM54).
HIBEC will help you comply with:
-
CIBSE Guides and Technical Memorandum TM37, TM54, TM59, TM33, TM52, AM10 etc
-
BB101 Guidelines on Ventilation, ThermalComfort & Indoor Air Quality in Schools
-
BREEAM
-
Approved Document F
This method allows for maximum flexibility where un-upgradable elements, poor controlled services or glazing areas in excess of the minimum allowed are required.