Construction U Values and Thermal Mass Kappa Values
It is the aim of Part L Conservation of Fuel and Power to ensure that buildings are thermally efficient.
The thermal efficiency of buildings is assessed in both SAP and SBEM in two ways:
1. The heat transmittance through the structure, defined as the U value in w/m2/oK.
2. The capacity of the structure to store (and release) heat, defined as the Thermal mass Kappa value in KJ/m2/oK.
HIBEC are independent (with no product to promote) and suitably qualified to undertake U and Kappa value calculations.
We understand how important these calculations are in gaining as much advantage in the SAP & SBEM calculations as possible.
We know that many specifications often refer to‘minimum standard U values to Part L’ even thoughthe construction detail is far better than that, oftenbecause no-one has carried out the actual U value calculation.
For example, the minimum U value may bespecified, which is 0.35w/m2/oK for a wall whilst the actual U value when calculated may be as low as 0.27w/m2/oK.
Do the same exercise for the floor and walls, and it is easy to see by getting HIBEC to undertake the U value calculations may be the difference between a pass and a fail of the SAP or SBEM.
Similarly, when we do a U value calculation, we add the additional material properties to find out the Kappa value, as this is also influential in the SAP and SBEM.
Often the fail caused by using assumed values are overcome by adding expensive renewable technologies, which is plainly daft.
Also as part of the U value calculation we issue a condensation report showing potential interstitial condensation risks within the construction layers, helping prevent future damp problems.